Gasboy FMS KE200 - Manual (Page 79)

MDE-4465A KE200 Key Encoder/Maintenance Terminal Operation Manual · October 2007 Page 73
Reading Key from the Keypad Encoding Keys
5 To accept the data in the field, press ENTER. To change the data in the field, type the new
value and press ENTER. The system displays the next field prompt.
6 Repeat step 5 until all fields are defined.
If you are only changing certain fields, or the data for this key is the same for the remaining
fields as the key before, you can use the ENCODE key as a shortcut to update the key. This
allows you to skip over any fields that do not have to be changed, and go directly to updating
the key. When you press ENCODE, the system skips any intermediate prompts, validates
remaining unentered data, and takes you immediately to the “ENCODE KEY” verification
prompt. If errors exist in the unentered data, the system displays “RANGE ERROR”. Press
ENTER to acknowledge the error condition and the system returns to the prompt in error so
you can make corrections.
The system displays the ENCODE KEY verification menu:
7 Press ENTER to encode the key. The system displays the following:
8 Remove the key and repeat this procedure from step 4 until all keys are encoded.
9 To return to the “ENCODE MENU” prompt, press PREV at the INSERT KEY prompt.
Reading Key from the Keypad
“ENCODE KEY” can be used to display all information contained on a specific key. Use this
option to view key data only. When reading a key, ensure that you have not changed any field
values loaded on the key. If you need to change any field data on a key, refer to the section
“Encoding from the Keypad” on page 72 .