Gasboy FMS KE200 User Manual
Page 51
MDE-4465A KE200 Key Encoder/Maintenance Terminal Operation Manual · October 2007
Page 45
Load IDFIELDS (LO ID)
KE200 Setup - Terminal
To use the “LOAD IDFIELDS” command, proceed as follows:
1
At the asterisk prompt, type “LO ID” and press ENTER. The system responds: “NO OF ID
FIELDS?”.
2
Type the number of ID fields for your FleetKey system and press ENTER. The system
displays a chart containing the ID fields and their current values.
The system then prompts: “FIELD NO?”
3
Type the number of the ID field you wish to define and press ENTER. The system responds
with the prompt: “FIELD NAME?”
4
Type a 1 to 12-digit name for the field. The name you enter must match the one on your
FleetKey system. Press ENTER. The system responds: “FIELD SIZE? <1-20>”.
5
Type the field size (1 to 20; {limited to 19 numeric for CFN}) and press ENTER. The field
size must be the same as that specified for this field on your FleetKey system. The system
responds: “FIELD FORMAT?
6
Type “A” or “N” for your field format and press ENTER. You have now completed definition
for one ID field. The system responds: “FIELD NO?”.
7
Repeat this procedure from step
to define additional ID fields. If you have defined all your
ID fields, press ENTER to exit to the asterisk prompt.