Gasboy FMS KE200 - Manual (Page 16)

System Overview Using the KE200 Keypad and Key Receptacle
Page 10 MDE-4465A KE200 Key Encoder/Maintenance Terminal Operation Manual · October 2007
Using the KE200 Keypad and Key Receptacle
The keypad for the encoder is simple, consisting of numeric keys 0-9, and the following keys:
Figure 1-8: KE200 Keypad and Receptacle
• ENTER transmits entered information to the encoder and allows you to move through the
prompts. It is also used to acknowledge and clear error or status messages.
• CLEAR clears the entry. It is used as a “NO” response to a verification prompt. When
pressed twice in encoding mode, it enters special field separators and supervisor entry
characters.
• F1 in Setup and Maintenance modes allows you to move to the next prompt. It is disabled
for Encoding mode.
• F2 in Setup and Maintenance modes allows you to move to the previous prompt. It is
disabled for Encoding mode.
• RESET in Encoding or Setup modes returns you to the first prompt in the group. It is
disabled in Edit mode.
• PREV in Encode mode returns you to the previously displayed prompt. If you are at the
first prompt in a group, you will exit to the Encode menu. In Setup or Maintenance modes,
it backs you out by group. Use the flow diagram in Section 2 to visualize the following:
If you are at FIELD SIZE, under the group SELECT ID FIELD and you press PREV
once, you return to SELECT ID FIELD. If you press PREV again, CONFIG ID MENU
displays. If you press PREV again, SETUP MENU displays.
• ENCODE in Encode mode skips any intermediate prompts, validates remaining
unentered data, and takes you immediately to the ENCODE KEY verification menu from
whatever prompt you were at. If errors exist in the unentered data, the system returns to
the prompt in error and displays RANGE ERROR.
• “A”, “B”, “C” selects maintenance category in Setup and Maintenance modes.
• A key receptacle on the right-hand side of the encoder face allows you to insert Fleetkeys
for encoding or maintenance updating.