Gasboy FMS KE200 - Manual (Page 47)

MDE-4465A KE200 Key Encoder/Maintenance Terminal Operation Manual · October 2007 Page 41
Load Date (LO DA) KE200 Setup - Terminal
To enter units of measure and the date format, proceed as follows:
1 At the asterisk prompt, type “LO CO” and press ENTER. The system responds with the
message: “UNITS? ”.
2 Press ENTER to accept the current setting or type an alternate setting and press ENTER. The
system responds, “DATE FORMAT? ”.
Load Date (LO DA)
Use “LOAD DATE” to load the current date and time. The KE200 should be factory set with
the correct date. However, you may have to change it occasionally.
The system validates the month, day, and year together, so if you type an invalid month, day,
or year, you will not be notified until you have typed in values for all three fields. Hours and
minutes are entered in 24-hour format (00:00 to 23:59) and are validated together. If you type
an invalid value for hours, you will not be notified until after you type a value for minutes.
To load date, proceed as follows:
1 At the asterisk prompt, type “LO DA” and press ENTER. The system responds: “MONTH?”
2 Type a valid month and press ENTER. The system responds: “DAY?”
3 Type a valid day and press ENTER. The system responds: “YEAR?”
4 Type a valid year and press ENTER. The system responds “HOUR?”
5 Type a valid hour (in 24-hour format) and press ENTER. The system responds: “MINUTE?”
6 Type the valid minutes and press ENTER.