Gasboy FMS KE200 - Manual (Page 34)

KE200 Setup - Standalone Configure Maintenance Table (1000 FleetKey only)
Page 28 MDE-4465A KE200 Key Encoder/Maintenance Terminal Operation Manual · October 2007
Load Transaction Number
Use “LOAD TRANS NUMBER” to load a starting number for your maintenance transactions.
To start your transactions at the number you desire, this command value must be set to the
number before the one you wish to start at (for example, if your first transaction is to be
number 1, set this command to zero).
To load Transaction number, proceed as follows:
1 From the “CONFIG MAINT TRANS” display, press ENTER. The system displays the
following:
MAINT TRANS MENU:
RESET TRANS POINTER
2 Press F1 until the system displays the following:
MAINT TRANS MENU:
LOAD TRANS NUMBER
3 Press ENTER. The currently loaded value appears on the second line of the display.
LOAD TRANS NUMBER:
0035
4 Type a 4-digit transaction number and press ENTER. The system returns to the following:
MAINT TRANS MENU:
LOAD TRANS NUMBER
5 To exit to the “SETUP MENU” prompt, press PREV, then press F1 to select another primary
prompt.
Configure Maintenance Table (1000 FleetKey only)
“CONFIG MAINTENANCE TABLE” is a menu item that provides access to two submenus
which allow you to load the maintenance table or clear the maintenance table. As discussed in
detail in the FleetKey Operation Manual, the Maintenance table consists of up to 20 classes of
vehicle, with the three maintenance types (A, B, and C) and a “MILES” and “DAYS” between
maintenance entry defined for each. The maintenance table you enter at the KE200 Encoder
must be identical to the one entered at the FleetKey system.
Use “CLEAR MAINT TABLE” when you start up your system or before the initial loading of
the maintenance table to clear out any leftover information that may be present from factory
testing. Use the “CLEAR” option with care as it deletes the entire maintenance table and loads
it with zeros.