Gasboy FMS KE200 - Manual (Page 85)

MDE-4465A KE200 Key Encoder/Maintenance Terminal Operation Manual · October 2007 Page 79
View Maintenance (1000 FleetKey only) Performing Maintenance
If you press CLEAR, no maintenance data is recorded on the key, the system displays,
“REMOVE KEY”. When you remove the key, the “MAINTENANCE MODE: PERFORM
MAINTENANCE” prompt reappears.
8 Press ENTER to update the key. The system displays the following:
An entry is made on the logger printout each time maintenance is performed. A sample entry
appears as shown below:
9 Remove the key and the display returns to “PERFORM MAINTENANCE: INSERT KEY”.
10 Repeat steps 2 to 9 until all keys are updated.
11 Press PREV to return to the maintenance mode: “MAINTENANCE MODE: PERFORM
MAINTENANCE” prompt.
View Maintenance (1000 FleetKey only)
Use “VIEW MAINTENANCE” to view the maintenance information that is encoded on the
key. Under usual circumstances, when you select “VIEW MAINTENANCE”, the system
displays the maintenance type, and the date and odometer reading at which maintenance was
last performed. The second line of the display shows the number of days and/or odometer
remaining until the next maintenance is due. Any of the following circumstances can cause
dashes to be displayed in the fields on the second line of the display:
• The maintenance information on the key equals 0
• The maintenance table data equals 0
• The maintenance odometer is greater than the last odometer on the key
• The maintenance date is greater than the current date
• The vehicle class on the key equals 0 (no maintenance)
Note: When maintenance is overdue, the second line of the display contains zeros.