Comtech EF Data SDM-300A - Manual (Page 449)

SDM-300A Satellite Modem Revision 6
Remote Control Operation MN/SLM3650.IOM
A–57
(Note 8)
(Note 9)
(Note 8)
(Note 8)
113
114
115
116
117
118
119
120
121
122
RX Reed-Solomon Interleave Value
(ref. 'RRSI_' command).
reserved null field.
reserved null field.
reserved null field.
TX 8PSK 2/3 IESS-310 Operation
(ref. 'T310_' command).
RX 8PSK 2/3 IESS-310 Operation
(ref. 'R310_' command).
Flex Mux Channel #1 Enable
(ref. "TCEN_1" command).
TX Flex Mux Channel #1 Data Rate
(ref. "TCDR_1" command).
TX Flex Mux Channel #2 Enable
(ref. "TCEN_2" command).
TX Flex Mux Channel #3 Enable
(ref. "TCEN_3" command).
p113 = nn, Interleave value.
p117 = n, where 'n' is '0' (off) or '1' (on).
p118 = n, where 'n' is '0' (off) or '1' (on).
p119 = n, where 'n' is '0' (Disabled), '1' (D&I), or '2' (for
T1/E1) operation.
p120 = nnnn.n, where 'nnnn.n' is the data rate in Kbps.
p121 = n, where 'n' is '0' (Disabled), '1' (Enabled).
p122 = n, where 'n' is '0' (Disabled), '1' (Sync RS422), '2'
(Async RS422), '3' (Sync RS232), '4' (Async RS232), or '5'
(AUPC operation).
(Note 10)
(Note 10)
123
124
TX Flex Mux Channel #3 Data Rate
(ref. "TCDR_3" command).
TX Flex Mux Channel #3 Clock Phase
(ref. "TCCP_3" command).
p123 = nnnn.n, where 'nnnn.n' is the data rate in Kbps.
p124 = n, where 'n' is '0' (Normal) or '1' (Invert).