Comtech EF Data SDM-300A - Manual (Page 412)

SDM-300A Satellite Modem Revision 6
Remote Control Operation MN/SLM3650.IOM
A–20
A.8 System Configuration Commands
Time Of Day Command:
Response:
Status:
Response: >add/TIME_hh:mmxx'cr''lf']
>add/TIME_hh:mmxx'cr''lf']
Where:
hh = 1 to 12 (hours).
mm = 00 to 59 (minutes).
xx = AM or PM.
Date
Command:
Response:
Status:
Response: >add/DATE_mm/dd/yyyy'cr''lf']
>add/DATE_mm/dd/yyyy'cr''lf']
Where:
mm = 1 to 12 (month).
dd = 1 to 31 (day).
yyyy = 00 to 99 (year) in 2 - digit year mode, and 1975 to 1999
and 2000 to 2075 in 4 - digit mode.
Remote Command:
Response:
>add/REM_'cr''lf'] Configures the modem for remote operation.
The SDM300A will respond to any status request at any time.
However, the SDM300A must be in 'Remote Mode' to change
configuration parameters.
Clear Stored
Faults Command:
Response:
>add/CLSF_'cr''lf'] This command is used to clear all stored faults logged by the
SDM300A.
Modem
Operation
Mode Command:
Response:
Status:
Response: >add/MOM_xxxxxxx'cr''lf']
>add/MOM_xxxxxxx'cr''lf']
Where: xxxxxxx = TX_ONLY, RX_ONLY, or DUPLEX.
This command configures the modem for simplex or duplex
operation modes. When transmit only mode is selected, receive
faults are inhibited and when receive only mode is selected,
transmit faults are inhibited.
System
Modem Type Command:
Response:
Status:
Response: >add/SMT_xxxxxxx'cr''lf']
>add/SMT_xxxxxxx'cr''lf']
Where: xxxxxx = IDR, IBS, DI, ASYNC, AUPC, EFD, CUSTOM,
OR VSAT-IBS, or CDM.
Save Modem
Config. Command:
Response:
>add/SMC_n'cr''lf'] Where: n = 1, 2, 3, 4, or 5 (stored configuration number).
This command saves the current modem configuration for recall
at a later time using the 'RMC_' command. Up to five different
modem configurations can be saved.