Comtech EF Data SDM-300A - Manual (Page 401)

SDM-300A Satellite Modem Revision 6
Remote Control Operation MN/SLM3650.IOM
A–9
Descramble
Enable Command:
Response:
Status:
Response: >add/DE_xxx'cr''lf']
>add/DE_xxx'cr''lf']
Where: xxx = ON or OFF.
Differential
Decoder
Enable Command:
Response:
Status:
Response: >add/DDEC_xxx'cr''lf']
>add/DDEC_xxx'cr''lf']
Where: xxx = ON or OFF.
Note: Always Off in Turbo mode.
RF
Loopback Command:
Response:
Status:
Response: >add/RFL_xxx'cr''lf']
>add/RFL_xxx'cr''lf']
Where: xxx = ON or OFF.
IF Loopback Command:
Response:
Status:
Response:
>add/IFL_xxx'cr''lf']
>add/IFL_xxx'cr''lf']
Where: xxx = ON or OFF.
Sweep
Center
Frequency Command:
Response:
Status:
Response: >add/SCF_snnnnn'cr''lf']
>add/SCF_snnnnn'cr''lf']
Where: snnnnn = -35000 to +35000, in 1 Hz steps.
Sweep Width
Range Command:
Response:
Status:
Response: >add/SWR_nnnnn'cr''lf']
>add/SWR_nnnnn'cr''lf']
Where: nnnnn = 0 to 70000, in 1 Hz steps.
Sweep
Reacquisi-
tion Command:
Response:
Status:
Response: >add/SR_xxx'cr''lf']
>add/SR_xxx'cr''lf']
Where: xxx = 0 to 999 (number of seconds).