Comtech EF Data SDM-300A - Manual (Page 165)

SDM-300A Satellite Modem Revision 6
Front Panel Operation MN/SDM300A.IOM
5–71
FUNCTION SELECT: REMOTE AUPC: CONFIGURATION:B-BAND
LOOP BACK (CONDITIONAL)
B-BAND LOOP BACK
OFF
IMPORTANT
Conditional: This is only available when the ASYNC / AUPC
overhead option is selected from the Modem Type menu, located
under the Utility: Modem Type menu.
Requires either the Overhead card installed with the ASYNC/AUPC
option or the Reed-Solomon card installed with AUPC option.
Programs the remote baseband loopback On or Off at the far end of the link. Modems at both
ends of the link must be locked.
This is for control or displays last known status.
FUNCTION SELECT: REMOTE AUPC: CONFIGURATION:TX 2047
PATTERN
TX 2047 PATTERN
OFF
IMPORTANT
Conditional: This is only available when the ASYNC/AUPC overhead
option is selected from the Modem Type menu, located under the
Utility: Modem Type menu.
Requires either the Overhead card installed with the ASYNC / AUPC
option or the Reed-Solomon card installed with AUPC option.
Programs the remote TX 2047 PATTERN On or Off at the far end of the link. Modems at both
ends of the link must be locked.
This program is for control or displays last known status.