Comtech EF Data SDM-300A - Manual (Page 414)

SDM-300A Satellite Modem Revision 6
Remote Control Operation MN/SLM3650.IOM
A–22
A.9 Automatic Uplink Power Control (AUPC)
A.9.1 Local Modem AUPC Commands
AUPC Local
Enable Command:
Response:
Status:
Response: >add/LPC_xxx'cr''lf']
>add/LPC_xxx'cr''lf']
Where: xxx = ON or OFF.
Notes:
1. When programmed ON, the MOP (Modulator Output
Power) command is not allowed, only MOP status is
allowed.
2. ASYNC or AUPC Overhead only.
AUPC
Nominal
Power Level Command:
Response:
Status:
Response: >add/NOMP_snn.n'cr''lf']
>add/NOMP_snn.n'cr''lf']
Where: snn.n = -30.0 to -5.0, in 0.1 steps (nominal range in
dBm).
Notes:
1. The nominal power range is modified relative to the
value specified by the modulator power offset
(MPO_).
2. ASYNC or AUPC Overhead only.
AUPC
Maximum
Power Limit Command:
Response:
Status:
Response: >add/MAXP_snn.n'cr''lf']
>add/MAXP_snn.n'cr''lf']
Where: snn.n = -30.0 to -5.0, in 0.1 steps (nominal range in
dBm).
Notes:
1. The nominal power range is modified relative to the
value specified by the modulator power offset
(MPO_).
2. ASYNC or AUPC Overhead only.
AUPC
Minimum
Power Limit Command:
Response:
Status:
Response: >add/MINP_snn.n'cr''lf']
>add/MINP_snn.n'cr''lf']
Where: snn.n = -30.0 to -5.0, in 0.1 steps (nominal range in
dBm).
Notes:
1. The nominal power range is modified relative to the
value specified by the modulator power offset
(MPO_).
2. ASYNC or AUPC Overhead only.
AUPC
Eb/N0
Target Set
Point Command:
Response:
Status:
Response: >add/ENSP_nn.n'cr''lf']
>add/ENSP_nn.n'cr''lf']
Where: nn.n = 3.2 to 16.0, in 0.1 increments (Eb/N0 in dB).
Note: ASYNC or AUPC Overhead only.