Destination operations car, Command and status registers settings, Data streaming logical layer control csr – Altera RapidIO II MegaCore Function User Manual
Page 40: Supported traffic management types reset value, Traffic management mode reset value, Maximum transmission unit reset value, Port general control csr, Destination operations car –10, Command and status registers settings –10, Data streaming logical layer control csr –10
3–10
Chapter 3: Parameter Settings
Command and Status Registers Settings
RapidIO II MegaCore Function
August 2014
Altera Corporation
User Guide
Destination Operations CAR
The Destination operations CAR override parameter supports user input to the
values of all of the fields of the Destination Operations CAR (
). You can use this parameter to specify that your RapidIO II IP core
variation handles some specific functionality through the Avalon-ST pass-through
port.
The 32-bit default value of the Destination Operations CAR is determined by the
functionality you enable in the RapidIO II IP core with other settings in the parameter
editor. For example, if you turn on Enable Maintenance module, the PORT_WRITE field
is set by default to the value of 1’b1. However, the actual reset value of the
Destination Operations
CAR is the result of the bitwise exclusive-or operation
applied to the default values and the value you specify for the Destination operations
CAR override
parameter.
For example, by default, the Data Message field of this CAR is turned off. However,
you can set the value of the Destination operations CAR override parameter to
32’h00000800 to override the default value of the Data Message field, to indicate that
user logic attached to the Avalon-ST pass-through interface supports data message
operations that the RapidIO II IP core receives on the RapidIO link. The RapidIO II IP
core supports reporting of data-message related errors through the standard Error
Management Extensions registers.
Command and Status Registers Settings
The Command and Status Registers tab lets you set the reset values for some of the
command and status registers (CSRs), which exist in every RapidIO processing
element. All CSRs are 32 bits wide.
Data Streaming Logical Layer Control CSR
The Data Streaming Logical Layer Control CSR is described in
Supported Traffic Management Types Reset Value
Supported traffic management types reset value
sets the reset value of the
TM_TYPE_SUPPORT
field of the Data Streaming Logical Layer Control CSR.
Traffic Management Mode Reset Value
Traffic management mode reset value
sets the reset value of the TM_MODE field of the
Data Streaming Logical Layer Control
CSR.
Maximum Transmission Unit Reset Value
Maximum transmission unit reset value
sets the reset value of the MTU field of the
Data Streaming Logical Layer Control
CSR.
Port General Control CSR
The Port General Control CSR is described in