Pilz PNOZ m B0 - Manual (Page 9)

Overview ­ Communication options
Operating Manual PNOZmulti 2 Communication Interfaces
1002971­EN­02 9
2.2 Communication via the communication modules
When communication takes place via a communication module, data exchange is defined
via a special protocol. This protocol is described in more detail in the chapter entitled
Com­
munication modules [ 26] .
The following device combinations are possible:
Communication Module Base units
PNOZ m ES RS232
PNOZ m B0
PNOZ m ES ETH
INFORMATION
If virtual inputs/outputs are to be downloaded via the communication module
(without using a fieldbus module), the interface "Inputs/outputs that are
downloaded via the integrated interface" must be configured in the hard­
ware configuration in the PNOZmulti Configurator.