Pilz PNOZ m B0 - Manual (Page 50)

Modbus/TCP
Operating Manual PNOZmulti 2 Communication Interfaces
1002971­EN­02 50
Register
(3x, 4x)
Coil/
Discrete Input
(0x, 1x) Content High Byte Low Byte
0 15... 0 State of virtual inputs
0...15 i15…i8 i7…i0
1 31... 16 State of virtual inputs
16...31 i31…i24 i23…i16
2 47...32 State of virtual inputs
32...47 i47…i40 i39…i32
3 63...48 State of virtual inputs
48...63 i63…i56 i55…i48
4 79... 64 State of virtual inputs
64...79 i79…i72 i71…i64
5 95...80 State of virtual inputs
80...95 i95…i88 i87…i80
6 111...96 State of virtual inputs
96...111 i111…i104 i103…i96
7 127...112 State of virtual inputs
112...127 i127…i120 i119…i112
The table below describes the Modbus/TCP data areas that contain the states of the virtual
outputs of the PNOZmulti 2.
Relevant areas for the data are defined in the Modbus/TCP data areas Discrete Inputs (1x)
and Input Register (3x). Read access is available to these data areas.
Register
(3x)
Discrete Input
(1x) Content High Byte Low Byte
512 8207...8192 State of virtual outputs
0...15 o15…o8 o7…o0
513 8223...8208 State of virtual outputs
16...31 o31…o24 o23…o16
514 8239...8224 State of virtual outputs
32...47 o47…o40 o39…o32
515 8255...8240 State of virtual outputs
48...63 o63…o56 o55…o48
516 8271...8256 State of virtual outputs
64...79 o79…o72 o71…o64
517 8287...8272 State of virtual outputs
80...95 o95…o88 o87…o80
518 8303...8288 State of virtual outputs
96...111 o111…o104 o103…o96
519 8319...8304 State of virtual outputs
112...127 o127…o120 o119…o112
A watchdog can be activated in Control Register 255.
If no input bits are set by a Modbus/TCP subscriber within the preset time, the PNOZmulti 2
will set the input bits to "0".