Versajet – Cino M230B User Manual
Page 97
88
Programming Reference
VERSAJET
Character height selection
Bit 2
Bit 1
Bit 0
Hex
Decimal
Height
Off
Off
Off
00
0
1(normal)
Off
Off
On
01
1
2(double-height)
Off
On
Off
02
2
3
Off
On
On
03
3
4
On
Off
Off
04
4
5
On
Off
On
05
5
6
On
On
Off
06
6
7
On
On
On
07
7
8
[Notes]
The character size set by this command is effective for alphanumeric, Kana, multilingual
and user-defined characters.
When the characters are enlarged with different heights on one line, all the characters on
the line are aligned at the baseline.
When the characters are enlarged widthwise, the characters are enlarged to the right,
base on the left side of the character.
ESC ! can also turn double-width and double-height modes on or off.
In standard mode, the character is enlarged in the paper feed direction when
double-height mode is selected, and it is enlarged perpendicular to the paper feed
direction when double-width mode is selected. However, when character orientation
changes in 90° clockwise rotation mode, the relationship between double-height and
double-width is reversed.