Cino M230B - Manual (Page 105)

96
Programming Reference
VERSAJET
For process of QR Code symbol (when cn = 49)
The symbol data specified by Function 080 d1...dk is stored in the printer and is printed
by the specification of Function 081. The symbol data in the save area is reserved until
the following processing is performed:
Function 080 or 180 or 980 is executed.
ESC @ is executed.
The printer is reset or the power is turned off.
Executing function 181 after executing Function 180 respectively prints the same symbol
data.
By using Functions 165, 167, 169 combined with Function 181, the same symbol data
d1...dk is printed differently.
This model supports two-dimensional code (PDF417 ). When printing PDF417 with this
printer, note the following:
The recognition rate of the symbol is affected by the height of the symbol, module
height, module width ratio, and the performance of the reader.
It is recommended that the module height be set three to five times the width of the
module.
The module height is specified by Function 068. The width of a module is specified by
Function 067. The number of the rows is specified by Function 066.