beautypg.com

Versajet – Cino M230B User Manual

Page 158

background image

149

Programming Reference

VERSAJET

[Notes]

In a count-up setting, when the GS c is executed, the counter value exceeds the

maximum value( bL+bH x 256), restart counting from the minimum value ( aL + aH x
256).

In a count-down setting, when GS c is executed, the counter value is below minimum

value( bL+bH x 256), restart counting from the maximum value ( aL + aH x 256).

In a count-stop setting, when executing GS c, the counter value is not changed.

This command does not change the counter value. The counter value is set by GS C 2.

Settings of this command are effective until ESC @ is executed, the printer is reset, or

the power is turned off.

The value of the counter is updated when executing GS c.