Cino M230B - Manual (Page 156)

147
Programming Reference
VERSAJET
GS C 0
[Name] Select counter print mode
[Format] ASCII GS C 0 n m
Hex 1D 43 30 n m
Decimal 29 67 48 n m
[Range] 0 ≤ n ≤ 5,
0 ≤ m ≤ 2, 48 ≤ m ≤ 50
[Default] n = 0, m = 0
[Description] Selects a print mode for the serial number counter (the number of printed digits and the print
position within the entire range of printed digits).
n specifies the number of digits to be printed.
When n=0, the printer prints the actual digits indicated by the number value.
When n≠0, the printer prints the last n digits of the serial number.
m specifies the printing position within the entire range of printed digits, as follows：
m Print position Processing of digits less than those specified
0,48 Align right Adds spaces to the left
1,49 Align right Adds 0 to the left
2,50 Align left Adds spaces to the right
[Notes]
The serial number counter is stored in the print buffer by GS c.
Settings of this command are effective until ESC @ is executed, the printer is reset, or
the power is turned off.