Cino M230B - Manual (Page 164)

155
Programming Reference
VERSAJET
GS P
[Name] Set horizontal and vertical motion units
[Format] ASCII GS P x y
Hex 1D 50 x y
Decimal 29 80 x y
[Range] 0 ≤ x ≤ 255, 0 ≤ y ≤ 255
[Default] x = 203, y = 203
[Description] Sets the horizontal and vertical motion units to 1/x and 1/y inch, respectively.
When x = 0, the default setting of the horizontal value is used.
When y = 0, the default setting of the vertical value is used.
[Notes]
The horizontal direction is perpendicular to the paper feed direction and the vertical
direction is the paper feed direction.
The horizontal and vertical motion units indicate the minimum pitch used for calculating
the values of related commands.
In standard mode, the following commands use x or y.
Commands using x: ESC SP, ESC $, ESC \, GS L, and GS W.
Commands using y: ESC 3, ESC J
In page mode, the following commands use x or y, when the starting position is set to
the upper left or lower right of the printing area using ESC T.
Commands using x : ESC 3, ESC J, ESC W, GS $, and GS \
Commands using y : ESC SP, ESC $, ESC W, ESC \