Cino M230B - Manual (Page 88)

79
Programming Reference
VERSAJET
FS S
[Name] Set left- and right-side MBCS character spacing
[Format] ASCII FS S n1 n2
Hex 1C 53 n1 n2
Decimal 28 83 n1 n2
[Range] 0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
[Default] n1= 0, n2= 0
[Description] Sets left- and right-side MBCS characters spacing n1 and n2.
When the printer model used supports GS P, the left-side character spacing is [n1x
horizontal or vertical motion units] and the right-side character spacing is [n2x horizontal or
vertical motion units].
[Notes]
When double-width mode is set, the left- and right-side character spacing is twice the
normal value.
The horizontal and vertical motion units are set by GS P. The previously specified
character spacing does not change, even if the horizontal or vertical motion unit is
changed using GS P.
The value cannot be less than the minimum horizontal movement amount, and must be
in even units of the minimum horizontal movement amount.