Cino M230B - Manual (Page 74)

65
Programming Reference
VERSAJET
This command setting has no effect in standard mode. If this command is processed in
standard mode, an internal flag is activated, and this flag is enabled when the printer
selects page mode.
The parameters for the horizontal or vertical motion unit differ, depending on the starting
position of the printing area as follows:
If the starting position is the upper left or lower right of the printing area:
These commands use horizontal motion units: ESC SP, ESC $, ESC \.
These commands use vertical motion units: ESC 3, ESC J, GS $, GS \.
If the starting position is the upper right or lower left of the printing area:
These commands use horizontal motion units: ESC 3, ESC J, GS $, GS \. These
commands use vertical motion units: ESC SP, ESC $, ESC \.
The settings of this command are effective until ESC @ is executed, the printer is reset,
or the power is turned off.