Cino M230B - Manual (Page 162)

153
Programming Reference
VERSAJET
GS L
[Name] Set left margin
[Format] ASCII GS L nL nH
Hex 1D 4C nL nH
Decimal 29 76 nL nH
[Range] 0 ≤ (nL + nH x 256) ≤ 384 (0 ≤ nL ≤ 255, 0 ≤ nH ≤ 1)
[Default] (nL + nH x 256) = 0 (nL = 0, nH = 0)
[Description] In standard mode, sets the left margin to (nL + nH x256) x (horizontal motion unit) from the
left edge of the printable area.
[Notes]
When standard mode is selected, this command is enabled only when processed at the
beginning of the line.
The left margin has no effect in page mode. If this command is processed in page mode,
the left margin is set and it is enabled when the printer returns to standard mode.
If the setting exceeds the printable area, it is ignored.
If this command and GS W set the printing area width to less than the width of one
character, the printing area width is extended to accommodate one character for the line.
Horizontal motion unit is used.
If horizontal motion unit is changed after changing left margin, left margin setting is not
changed.