Cino M230B - Manual (Page 58)

49
Programming Reference
VERSAJET
ESC 3
[Name] Set line spacing
[Format] ASCII ESC 3 n
Hex 1B 33 n
Decimal 27 51 n
[Range] 30
≤
n
≤
255
[Default] Amount of line spacing which corresponds to “default line spacing” (See ESC 2 for the line
spacing).
[Description] Set the line spacing to nx (vertical or horizontal motion unit).
[Notes]
The maximum line spacing is 320mm. If the specified amount exceeds 320mm, the line
spacing is automatically set to 320mm. When standard mode is selected, the vertical
motion unit is used. When page mode is selected, the vertical or horizontal motion unit is
used for the print direction set by ESC T.
When the starting position is set to the upper left or lower right of the printing area using
ESC T, the vertical motion unit is used.
When the starting position is set to the upper right or lower left of the printing area using
ESC T, the horizontal motion unit is used.
The line spacing can be set independently in standard and page mode.
In standard mode this command sets the line spacing of standard mode.
In page mode this command sets the line spacing of page mode.