Carrier Access Broadmore 1750 - Manual (Page 359)

Broadmore 1750 - Release 4.6 12-41
SNMP Configuration
Notify Filters
NOTE: Selecting Validate Table will check that each Profile Name in
this table exists in the Notify Profiles table.
The Notify Filters table is used to avoid sending traps for specific mib variables. Each
variable in the VarBindList is checked against the Subtree. If a match occurs, the trap
is not sent.
The following table describes the selections.
Item Options Comments
Profile Name string Value for Profile Name, 1 to 30 characters.
Note: This entry must agree with the Profle Name
in the Notify Profiles table (see “Notify Profiles”
on page
12-42 ).
Subtree bit string The MIB tree address indicating the branch nodes
to be filtered.
Subtree Mask bit string The "mask" is a bit string where a “1” ignores the
corresponding OID bit and a “0” indicates a wild
card match for the corresponding OID bit. A string
of all “1” bits will accept any OID.
Type Included
Excluded Must be same as in Notify table.
Enabled Enabled
Disabled Enables/disables this filter.
Storage Volatile
Non-volatile
Permanent
Readonly
Other Settings lost without power.
Settings can be changed.
Settings can not be deleted.
Settings can not be changed.