Carrier Access Broadmore 1750 - Manual (Page 160)

7-46 Broadmore 1750 - Release 4.6
Configuration
Unstructured DS3 SAM
Table 7-4: Unstructured DS3 SAM Alarm Configuration
Follow the sequence below to set network alarms. DS3 alarms are set on a port basis
with alarm definitions as shown.
Network AIS Activate/Deactivate Sends Alarm Indication Signal to the network
when activated.
Service AIS Activate/Deactivate Sends Alarm Indication Signal to the
connected local service equipment when
activated.
Loopback Normal
Local
Remote
Normal is no loopback.
Local sets a service side loopback (DS3) on the
port.
Remote sets a network side loopback (ATM)
on the port.
See diagram “Loopback Options” on page 5-20
Network Alarms Options Service Alarms
Cell Starvation Ignore/Major/Minor LOS
LOF Ignore/Major/Minor LOF
AIS Ignore/Major/Minor AIS
Idle Ignore/Major/Minor Idle
RAI Ignore/Major/Minor RAI
FEAC Ignore/Major/Minor FEAC
Sequence Errors Ignore/Major/Minor Line Code Violation
Excessive SNP Errors Ignore/Major/Minor Excessive SNP Errors
Excessive F-bit Errors Ignore/Major/Minor Excessive F-bit Errors
Excessive Parity Errors Ignore/Major/Minor Excessive Parity Errors
Excessive C-bit Errors Ignore/Major/Minor Excessive C-bit Errors
Excessive FEBE Errors Ignore/Major/Minor Excessive FEBE Errors
Item Options Comments