Carrier Access Broadmore 1750 - Manual (Page 351)

Broadmore 1750 - Release 4.6 12-33
SNMP Configuration
Targets
Targets
This selection allows you to enter up to 10 target IP addresses to receive trap
notifications. The screen below shows the New Targets Entry.
Follow the sequence below to modify the list.
Select System Management
↵
Select Configuration
↵
Select System Services
↵
Select SNMP Configure
↵
Select one of the following:
* Edit
↵,
edit the Target information
* Copy
↵,
(to put a copy of the information into the list)
* Delete
↵
, delete an existing Target
* New
↵,
enter a new Target
With each selection, confirm your changes and press Esc to exit.
Select Targets
↵
* Validate Table
↵,
check table entries for consistency