Carrier Access Broadmore 1750 - Manual (Page 317)

Broadmore 1750 - Release 4.6 11-51
Security Management (FIPS Mode)
Network Interfaces
Network Interfaces
Network Interface Modules (NIMs) are installed in the Broadmore ATM
Multiplexer and provide an interface to the ATM network. Each NIM contains
non-volatile Flash memory for storing run-time code. These chips are not
physically accessible from the ATM data path and thus cannot store data that
passes through the Broadmore.
Sanitation Procedures
The following table summarizes procedures for all Broadmore modules when
removing them from authorized areas to open areas.
Product Release Product Type Sanitation Procedure
Release 3.8
and earlier Broadmore Unit Power Off for 24 hours
Remove Disk-on-Chip from CPU
Network Interface
Modules Power Off for 24 hours
CPU Power Off for 24 hours
Remove Disk-on-Chip from CPU
Release 4.0
and later Broadmore Unit FIPS Zeroize Global/Standby
Power Off for 24 hours
Network Interface
Modules Power Off for 24 hours
CPU FIPS Zeroize Standby
Power Off for 24 hours