AERCO C-More Controls Manual June 2010 - Manual (Page 40)

C-More Controller for Benchmark, Innovation & KC
USER MANUAL
Page 40 of 162 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, New York 10913 04/22/14
GF-112 Phone: 800-526-0288 OMM-0032_0E
Table 3-1: Menu Item Descriptions - Continued
MENU LEVEL & OPTION DESCRIPTION
Combustion Cal Menu (Controller Software Version 3.07.xx)
NOTE: The CAL Voltage xx% values may differ according to the unit Size & Fuel Type selected
in the Configuration Menu. Refer to Table 3-2A for setting & defaults for all unit sizes.
*CAL Voltage 16%
Allows for the selection of the Blower Motor output voltage at 16%
*CAL Voltage 30% Allows for the selection of the Blower Motor output voltage at 30%
*CAL Voltage 45% Allows for the selection of the Blower Motor output voltage at 45%
*CAL Voltage 60% Allows for the selection of the Blower Motor output voltage at 60%
*CAL Voltage 80% Allows for the selection of the Blower Motor output voltage at 80%
*CAL Voltage 100% Allows for the selection of the Blower Motor output voltage at 100%
Set Valve Position Allows for setting of VALVE POSITION.
Blower Output Allows for the monitoring of Blower Output Voltage.
SET Stdby V Out
The Blower Motor remains “ON” in STANDBY Mode. The motor
speed is defined by setting this parameter to a non0zero value.
Default for INNOVATION WH is 1.00 Volts. All others are 0 Volts.
Combustion Cal Menu (Controller Software Version 3.08.xx)
NOTE: The CAL Voltage percent values shown apply to all Innovation Water Heater sizes and
Fuel Type used. However, the default voltage settings may vary depending on unit size and fuel
used. Refer to Table 3-2B for default voltage settings associated with each unit size and fuel type.
*CAL Voltage 16%
Allows for the selection of the Blower Motor output voltage at 16%
*CAL Voltage 20% Allows for the selection of the Blower Motor output voltage at 20%
*CAL Voltage 30% Allows for the selection of the Blower Motor output voltage at 30%
*CAL Voltage 40% Allows for the selection of the Blower Motor output voltage at 40%
*CAL Voltage 50% Allows for the selection of the Blower Motor output voltage at 50%
*CAL Voltage 60% Allows for the selection of the Blower Motor output voltage at 60%
*CAL Voltage 80% Allows for the selection of the Blower Motor output voltage at 80%
*CAL Voltage 100% Allows for the selection of the Blower Motor output voltage at 100%
Set Valve Position Allows for setting of VALVE POSITION.
Blower Output Allows for the monitoring of Blower Output Voltage.
SET Stdby V Out
The Blower Motor remains “ON” in STANDBY Mode. The motor
speed is defined by setting this parameter to a non0zero value.
Default for INNOVATION WH is 1.00 Volts. All others are 0.00
Volts.