AERCO C-More Controls Manual June 2010 - Manual (Page 17)

C-More Controller for Benchmark, Innovation & KC
USER MANUAL
04/22/14 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, New York 10913 Page 17 of 162
OMM-0032_0E Phone: 800-526-0288 GF-112
SECTION 2 - CONTROL PANEL MENU STRUCTURE
2.1 CONTROL PANEL MENUS
The Control Panel incorporates an extensive menu structure which permits the operator to set
up, and configure the unit. The menu structure consists of seven (7) major menus, as shown in
Figure 2-1. Each menu contains options that permit operating parameters to be viewed or
changed. The menus are protected by two different password levels to prevent unauthorized
use.
• Password Level 1 allows viewing of all menu categories and also allows the Setup,
Configuration and Tuning Menu options to be changed. For Software Version 3.08.xx,
the user-selectable options in the WHM menu can also be viewed or changed.
• Password Level 2 allows viewing and changing of all Level 1 menu categories and also
allows access to the Combustion Calibration (Cal), Calibration and Diagnostic Menus.
For Software Version 3.08.xx, additional options in the WHM menu can be viewed or
changed. These additional menu categories should only be used by factory trained
personnel to calibrate and troubleshoot the unit.
A third Password Level called the Factory Password also exists. However, access to this menu
is restricted to Factory Authorized personnel only.
Prior to entering the correct password, the options contained in the Operating, Setup,
Configuration and Tuning Menu categories can be viewed. However, except for Internal
Setpoint Temperature (Configuration Menu), none of the viewable menu options can be
changed.
Once the valid Level 1 (159) or Level 2 (6817) password is entered, the options listed in the
available menus can be viewed and changed, if desired.
2.2 MENU PROCESSING PROCEDURE
Accessing each menu and option is accomplished using the Menu Keys shown in Figure 1-1.
Therefore, it is imperative that you be thoroughly familiar with the following basic steps before
attempting to perform specific menu processing procedures.
1. The Control Panel will normally be in the Operating Menu and the VFD will display the
current unit status. Pressing the
▲ or ▼ arrow key will display the other available data
in the Operating Menu.
2. Press the MENU key. The display will show the Setup Menu that is the next menu
category shown in Figure 2-1. This menu contains the Password option which must be
entered if other menu options will be changed.
3. Continue pressing the MENU key until the desired menu is displayed.
4. With the desired menu displayed, press the
▲ or ▼ arrow key. The first option in the
selected menu will be displayed.