KEYENCE LV-N10 Series - Manual (Page 99)

App
endi
x
6-5 - Digital Laser Sensor LV-N10 Series User's Manual -
6
6-2
Factory Default Setting (Default Value) List
The default settings are as follows.
*1 Not available for the 0-line type.
*2 Only monitor output type.
*3 Main unit only.
*4 Only 2-output type
*5 Only when LV-NH100/NH110/NH300 is connected.
Refer to "Initialization of Settings (Reset to Initial Values)" (page 3-21)
for the initializing method.
Function Display Default value
Reference
page
Power mode turb turb (TURBO mode) 4-4
Sensitivity setting SEt Std (Normal sensitivity setting) 4-4
Output timer toFF ---- (Timer disabled) 4-7
Detection mode dEtc Std (Received light intensity detection mode) 4-8
External input
*1 in oFF (External input off) 4-17
Analog output scaling
*2 AnLG 4000 (0 to 4000, 1 to 5 V) 4-20
Display reverse rEu oFF (Normal display) 4-22
Sub-display Sub oFF (Sub-display off) 4-22
Preset saturation Pr-H on,110P (110%) 4-27
Power save Eco oFF (Off) 4-29
Display gain GAin Std (Standard light intensity display) 4-30
Interference prevention intF Std (Normal operation) 4-31
Common key operation function
*3 LinK oFF (Disabled) 4-32
Sensitivity hYS Std (Standard resolution) 4-32
Output2 detection mode
*4 2ch Std (Received light intensity detection mode) 4-33
Output2 output timer
*4 toFF ---- (Timer disabled) 4-37
Parameter Save by Ext-Input pRoG yes (Will be written) 4-19
Preset display mode
*5 pR-d PrSt (Normal preset display) 3-11
Analog scaling mode
*2 pR-a Std (Follows scaling setting) 4-21
Item Default value
Reference
page
Setting value (Detection mode: Std selected) 50 4-4
Setting value (Detection mode: dtM1 selected) 5.0 4-9
Setting value (Detection mode: dtM2 selected) 5.0 4-11
Setting value (Detection mode: ArEA selected) 50 4-14
Setting value (Detection mode: _|~d selected) 50 4-16
Setting value (Detection mode: ~|_d selected) 50 4-16
Percentage calibration target value -10P 4-5
Timer value All 10 4-7
2-output timer value All 10 4-37
Reference