KEYENCE LV-N10 Series - Manual (Page 28)

3
Ba
sic
Oper
ati
on
3-4 - Digital Laser Sensor LV-N10 Series User's Manual -
3-2
Switching Output
This function configures when the output turns ON.
1
When the current received light inten-
sity is displayed, press the [MODE] but-
ton.
The current output condition (L-on or D-
on) is displayed.
*1
2
Press the button to switch the out-
put condition, and then press the
[MODE] button.
Select "D-on" if you want to output the ON
signal when the beam is blocked (a work-
piece is present.) for a thrubeam or retro-reflective model.
Select "L-on" if you want to output the ON signal when the beam is received (a
workpiece is present.) for the reflective model.
The output condition is switched, and the current received light intensity is dis-
played.
*2
*1 If you do nothing for 3 seconds or more or press the [MODE] button, the received
light intensity display is automatically restored.
*2 When using the sub-display, the screen will switch between the current received
light intensity J L-on/D-on screen J sub-display J current received light intensity
and so forth each time the [MODE] button is pressed.
"Sub Display" (page 4-22)
• When in area detection mode, rising edge detection mode, falling
edge detection mode, counter output mode, or when the LV-S31 is
connected, this function works as a normally-open/normally-
closed switch.
"Area detection mode" (page 4-14)
"Rising edge detection mode" (page 4-16)
"Falling edge detection mode" (page 4-16)
"Counter output mode" (page 4-35)
• With the 2-output type, channels 1 and 2 can be configured sepa-
rately.
Output Switch (L-on/D-on)
Point