KEYENCE LV-N10 Series - Manual (Page 56)

4-3 Detection Settings (Func)
4
Set
tings
for Ad
van
c
ed Fu
nct
ion
s
4-8 - Digital Laser Sensor LV-N10 Series User's Manual -
The table below lists the detection modes that can be selected.
*1 In the DATUM mode, correction intervals can be set in the range of LEv1 to LEv3.
The default is LEv1.
Also, the warning output level can be set in the range of 0P (0%) to 100P (100%).
The default is 50P.
"Adjusting the correction interval" (page 4-12)
"Changing the warning output level" (page 4-13)
*2 This cannot be selected when LV-S31 is connected.
• Refer to "Detection Mode for Output2" (page 4-33) for details on
the 2-output type channel 2 detection mode.
• Refer to "Restrictions on Each Detection Mode" (page 6-8) for
restrictions on the sensitivity setting methods.
Detection Mode
Refer to page 4-2 "Detection Settings (Func)" for setting methods.
Display Detection mode Function
Reference
page
Std Normal detection Normal detection mode (Default) -
dtM1 DATUM1 mode
*1 *2
The received light intensity when
there is no workpiece is always cali-
brated to "
100.0 ", and the setting
value is also calibrated so that the set-
ting value and received light intensity
ratio is always constant.
4-9
dtM2 DATUM2 mode
*1 *2
The received light intensity when
there is no workpiece is always cali-
brated to "
.0 ", and the setting value is
also calibrated so that the setting
value and received light intensity ratio
is always constant.
4-11
ArEA Area detection mode
Detection is made only when the
received light intensity goes out of a
given range.
4-14
_|~d
Rising edge detection
mode
*2
Detection is made only when the
received light intensity increases.
4-16
~L_d
Falling edge detection
mode
*2
Detection is made only when the
received light intensity decreases.
4-16
Point