Panasonic WV-CU20 - Manual (Page 61)

• Mute
Muting is available when audio is unnecessary.
1. Press the MUTE button. The Control site stops sending
audio while the monitor displays the status indication
“MUTE” on the Control site.
2. To select a preset position.
2-1 Press the [*] PRESET button.
2-2 Enter a preset position with the numeric button{s)
from 1 to 64.
2-3 Press the [#] SET button.
The image of the selected position appears on the Control
site monitor.
VIDEOl
Trans.01
JAH.01.01 00:00:00£
MUTE
2. Press it again to resume audio data transmission.
• Operating Combination Cameras
Combination cameras directly connected to the transmitter
unit can be controlled from the Control site while these sites
are in communication.
1. To change the video input
Enter an input number with the numeric button from 1
to 5, then press the [#] SET button. The image of the
selected input appears on the Control site monitor.
2-2
2-3
3. Pan/tilt control
Press any of the direction buttons to direct the
Combination camera head toward the desired point.
4. Zoom control
Press the TELE or WIDE button to zoom out or in the
image.
5. Focus control
Press the NEAR or FAR button to adjust the focus man­
ually. Press the AF (automated focus) button to let the
camera adjust the focus by itself.
Multi-Site Operation
When the system is made up of multiple sites, the following
may take place on the Remote and Control sites.
A Remote site will reject new access from the Control site,
when it establishes connection with four Control sites. Wait
for a while and retry when you are the 5th caller to the
Remote site.
61