Mode dip switch [mode – Panasonic WV-CU20 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
® Mode DIP Switch [MODE]
The default setting is marked with *.
After changing the DIP switch, make sure to turn OFF
the power switch once and then turn it ON, or press the
RESET button to take in the new settings to the unit.
ON-
OFF'
□
□ □ □ □ □ □ □ d
123 4 5 6 7 8 9 1 0
Bit #
OFF
ON
Function/Note
1
Normal Operation *
initialize(l)
Maintenance
2
Normal Operation ’
initialize(2)
HTML file
3
*
Not Used
4
See below *
Applicable Line
5
See below *
Applicable Line
6
Normal Operation*
lnitialize(3)
Network
Configuration
7
-
Not Used
8
Setup Menu
Enabled *
Menu Disabled
Setup Menus
9
RS-485 Rear
RS-232C Front*
Host Port
Selection
10
*
Not Used
lnitialize(l) will reset all settings Including IP address back
to the factory default,
lnitialize(2) will reset the HTML contents files back to the
factory default settings.
Initialize(3) will reset the IP address, subnet mask and
default gateway back to the factory default settings.
Applicable Line
Bit #4
OFF
ON
Bit #5
OFF
AUTO *
10BASE-T
ON
100BASE-TX
AUTO
12