Wj-fs616 video multiplexer control, Connection, Setup – Panasonic WV-CU20 User Manual
Page 108: Camera select, Preset select, Cd wj-fs616 control panel, 4) wj-hd100 control panel
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
■ WJ-FS616 Video Multiplexer Control
• Connection
(1) Connect MULTISCREEN OUT on the rear of the WJ-FS616 to VIDEO IN 1 on the rear of the WJ-NT204.
(2) Connect the RS-485 ports of both units with a RS-485 cable.
Note: Set DIP switch #3 on the rear of WJ-NT204 to ON.
• Setup
(1) On the ADMINISTRATOR SETUP PAGE, click the [SERIAL PORT] button to open the SERIAL PORT SETUP window. For
TYPE, select WJ-FS616. Set the same communication parameters as for the WJ-FS616.
(2) On the ADMINISTRATOR SETUP PAGE, click the [MODE SETUP] button to open the MODE SETUP window.
Make the CONTROL SETUP as follows.
CAMERA CONTROL: OTHERS
AUX SYSTEM: WJ-FS616
• Control Operation
On the Location bar, type WJ-FS616 OPERATION VIEW window.
1 y/1 V iu • IIV
W-FS616 Si;:
OPHlULTTOiJ VIEW i, ':]
.................................................................^-|
■4^
® CAMERA SELECT
To select a camera (camera 1 to 16) connected to the
WJ-FS616 Video Multiplexer. The image of the selected
camera is displayed in spot mode.
® PRESET SELECT
To move the combination camera (option) connected to
the WJ-FS616 to any of 8 preset positions.
CD
WJ-FS616 CONTROL PANEL
Opens the WJ-FS616 control panel on the bottom cen
ter of the window.
Scroll down the left window panel to display the follow
ing buttons 4-6.
(4)
WJ-HD100 CONTROL PANEL
Opens the WJ-HDIOO control panel on the bottom cen
ter of the window.
108