700 remote setup edit (receiver in communication), Notes, 100 configuration – Panasonic WV-CU20 User Manual

Page 52: 200 receiving regi, 300 directory/dialing regi, 210 receiving regi

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

■ 700 REMOTE SETUP EDIT (Receiver in

Communication)

This menu lets the Control site (receiver) pull out the

Remote site's (transmitter) setups to change them. The

Control site transmits the modified setups to upload them

back to the Control site. The monitor screen changes to
blue during upload or download. To monitor the image, dis

connect once, then connect again,

Notes:
• Up/Download can be made only by the site using a WV-

CU20 Remote Controller.

• All the Remote site devices connected to the transmitter

will be disconnected once when the upload ends. The
transmitter will enter system reset mode to reflect the

renewed settings. You need make connection after

operating upload because that re-connection is not
applied to this case,

1, Select the 700 in the 000 TOP menu, then press the

ENTER.

000 TOP

100 CONFIOURATIONi (TRANSMITTER)
200 RECEIVING REQI.1
300 DIRECTORY/DIALING REOI.1
400 SETUP4.
500 CONTROL!
600 MAINTENANCE!

700 REMOTE SETUP EDIT!

t!;MOVE ENTiSELECT ESC;CLEAR

2. A message "DOWNLOAD? (REMOTE TO LOCAL)’’

appears. Select YES or NO with the or ► button,

then press the ENTER.

■DOWNLOAD? (REMOTE TO LOCAL)

YES NO

b-»; SELECT ENT; EXEC ESC ¡CLEAR

3. A message "NOW DOWNLOADING, PLEASE WAIT"

appears. Wait until the menu changes.

■NOW DOWNLOADING

PLEASE WAIT

ESC:QUIT

When the ESC button is pressed during the download,

a dialog appears asking whether to quit. Select YES or

NO, then press the ENTER.

YES: Escapes from the download.
NO: Continues the download.

4. The 700 REMOTE SETUP EDIT appears when data

transmission ends successfully.

700 REMOTE SETUP EDIT

100

CONFIGURATION!(TRANSMITTER)

200 RECEIVING REOI.!
300 DIRECTORY/DIALING REOI.!
400 SETUP!

UPDATED

JAN.01.01

00;00

t!;MOVE ENT¡SELECT ESC:PRV

5. Move the cursor to the item you wish to edit with the A

or T button, then press the ENTER. The selected menu
appears. Each menu is the same as described before.

100 CONFIGURATION:

200 RECEIVING REGI.:
300 DIRECTORY/DIALING REGI.:
400 SETUP:

Remember that you are manipulating the Remote site’s
menu from the Control site.

6. Edit the necessary settings by opening the menus

shown in the step 5 above.

7. Press the ESC button. The 700 REMOTE SETUP EDIT

menu is recalled.