Panasonic WV-CU20 - Manual (Page 130)

Ф Unit/System SELECTION
This selection changes the Control Operation window
to that of the selected unit while connmunicating with
the unit.
Pull down the button to display the registered title and
PSD unit #. Select the respective unit nunnber you wish.
The window changes to the selected unit’s where you
can control it. For exannple, you should select number 1
for WJ-FS416, or number 2 for WJ-HD100.
@ WJ-HD100 SELECT
These buttons are used to select the input image to
VIDEO IN 1-4 on the WJ-NT204 supplied from Hard
Disk Reoorders when a maximum of four Recorders are
connected. In this connection example, only the button
1 performs because a single Recorder is connected
(not directly, but via FS416} to VIDEO IN 1.
(D WJ-HD100 ALARM LIST ON
Displays the alarm list activated on the WJ-HD100
while opening the alarm control panel.
@ ALARM RESET
Resets the alarm mode activated on the WJ-HD100
and other devices in the PS'Data chain.
© Status Window
Displays information when an alarm is activated on the
WJ-HD100.
® Image Display
Displays the playback image on the WJ-HD100.
(Z) REW (TOP FRAME)
Rewinds the recorded image on the WJ-HD100 to the
start position.
® REV-PLAY
Plays back the recorded image reversely.
® PREV FRAME
Returns the frame one step to the previous while paus­
ing.
® PAUSE
Pauses the playback image.
® NEXT FRAME
Forwards the frame one step to the next while pausing,
© PLAY
Plays back the recorded image.
© FF
Fast-forwards the recorded image on the WJ-HD100 to
the end position.
® VARIABLE PLAY SLOW
Slows down the speed when playing back the image
normally, or speeds up when playing reversely.
® VARIABLE PLAY FAST
Increases the speed when playing back the image nor­
mally, or slows down when playing reversely.
® PLAY STOP
Stops playbacks including REV, REW and FF playback.
® REC
Starts recording.
® REC STOP
Stops recording.
© TIME & DATE Search
Retrieves the recorded image data designated by the
entered time and date. Type in a 14-digit number com­
prising YYYYMMDDhhmmss, then click GO button to
access to the data.
For an example, "20010121181535” indicates as fol­
lows.
YYYY: stands for year, year of 2001
MM: stands for month, 01 (Jan.)
DD: stands for day, 21 (twenty-first)
hh: stands for hour, 18 (6 o’clock pm), in the 24-
hour system
mm: stands for minute, 15 (fifteen minutes)
ss: stands for second, 35 (thirty five seconds)
Playback starts from the designated point when the
data was found, or starts from the closest point
ascending from the designation when not found.
The alarm control panel appears
ALARM LIST button is clicked. when WJ-HD100
MOVE CURSOR
Moves the cursor up or down while displaying the WJ-
HD100 ALARM LIST to select a recorded event in the
list.
PLAY/SET
Starts playing back of the image designated v/ith the
cursor when the alarm list is displayed.
Resets alarm data when DATA CLEAR is highlighted.
ALARM LIST OFF
130