Panasonic WV-CU20 User Manual
Panasonic, Operating instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Table of contents
Document Outline
- Panasonic
- IMPORTANT SAFETY INSTRUCTIONS
- Caution:
- WARNING:
- Audio/Video Transmission
- Access to the Site
- Peripheral Interfaces
- Setup menus
- Do not attempt to disassemble the appliance.
- Handle the appliance with care.
- Do not expose the appliance to water or moisture, nor try to operate it in wet areas.
- Do not use strong or abrasive detergents when cleaning the appiiance body.
- Do not operate the appliance beyond its specified temperature, humidity or power source ratings.
- ■ Basic Connection with WJ-NT204 Receiver
- Basic Connection with PC Browser
- ■ Multi-Site Connection
- ■ Access from an Internet
- Front View
- Rear View
- @ Video Input [VIDEO IN 1,2, 3, 4]
- ® Auxiliary Video Input [AUX IN]
- Audio Input [AUDIO IN]
- (g) Video Output [VIDEO OUT 1, 2, 3, 4]
- Monitor/Spot Output [MON/SPOT]
- Audio Output [AUDIO OUT]
- % Sensor Input/Trigger Output [SENSOR IN/TRIGGER OUT]
- Controller Port [REMOTE]
- RS-485 Host Port [RS-485 HOST PORT]
- RS-485 Host port
- RS-485 Data port
- ® Setup DIP Switch [SETUP]
- RS-485 Data Port [RS-485 DATA PORT]
- RS-232C Data Port [RS-232C DATA PORT]
- (g) Ethernet Port [10BASE-T/100BASE-TX]
- Signal Ground [SIGNAL GND] AC Inlet [AC IN]
- WV-CU20 Remote Controller (Option)
- @ One-touch Dial Buttons [ONE TOUCH DIAL, 1 - 5]
- © Switch Site Button[SWITCH SITE, 3]
- ® Video Scanning Mode Button [VIDEO AUTO/MANU, 4]
- ® Alarm Acknowledge Button [ALM ACK, 5]
- © Dial Button [DIAL]
- @ Quick Dial Button [QUICK]
- © Call Button [CALL]
- © Redial Button [REDIAL]
- © # SET Button [#, SET]
- ® Delete Button [DELETE]
- @ Numeric Buttons [0 - 9]
- © X PRESET Button [ X ^ preset]
- Escape Button [ESC]
- Direction Buttons [ < Ak W]
- Menu Button [MENU]
- Audio Mute Button [AUDIO MUTE]
- Enter Button [ENTER]
- Camera Control Buttons
- Connection Port
- The following installations should be made by qualified service personnel or system installers and should conform to all local codes.
- For permanetly connected unit, a readily accessible disconnection device shall be incorporated in the fixed wiring:
- [To working personnel]
- Mounting in the Rack
- ■ On the Remote Site (Transmitter)
- ■ On the Control Site (Receiver)
- ■ PC Connection
- I Prior to Setup
- Buttons Used for the Setup
- ■ Setup Menus
- ■ 100 CONFIGURATION
- 200 RECEIVING REGI.
- 300 DIRECTORY DIALING REGI.
- ■ 400 SETUP
- ■ 500 CONTROL (Transmitter only)
- ■ 600 MAINTENANCE
- ■ 700 REMOTE SETUP EDIT (Receiver in Communication)
- • Screen Display
- • About Power ON/OFF
- • Direct Dialing
- • Quick Dialing
- 2-2
- One-touch Dialing
- Redialing
- ■ Sequential Dialing (Receiver)
- 2-1
- 2-2
- # Manual Reception
- Alarm call reception
- • Automated Reception
- 0 Changing View Points during SEQ SCAN (sequential scan)
- • Mute
- • Operating Combination Cameras
- 2-2
- Multi-Site Operation
- Computer Requirements
- LAN Type Connection
- ■ WJ-NT204 Setup
- ■ Main Page and Control Windows
- ■ Installing an H.323 Plug-in to PC
- ■ About Operation Windows
- ■ Operation Mode
- ■ Push Mode
- ■ Image Quality Setup
- ■ ALARM LIST Window
- SETUP RROCEDURÈS
- ■ How to Read ADMINISTRATOR SETUP PAGE
- Notes:
- [SET][SUBMrn button
- [SET & REBOOT] button
- CD MODE SETUP
- CD NETWORK
- (D VIDEO SEQ/ALARM
- CD SERIAL PORT
- ® DATETTIME
- (D CAMERA MENU
- ® DIRECTORY
- ® ALARM TABLE SETUP
- ® OTHERS
- ® MAINTENANCE
- (Э RETURN TO MAIN PAGE
- © MAIN PAGE DEFAULT MODE & INDEX FILE SELECT
- MODE
- CAM CONTROL
- AUX SYSTEM CONTROL
- ® IP ADDRESS (LAN)
- (D NETMASK (LAN)
- (D DEFAULT GATEWAY (LAN)
- ■ VIDEO SEQ/ALARM SETUP
- SERIAL PORT SETUP
- ® TYPE
- © BAUD RATE
- (D DATA BIT
- ® UNIT ADDRESS
- ® GROUP ADDRESS
- @ PS'Data Unit Address SETUP
- ® WJ-DR200 SETUP
- (Q) WJ-SX550A/B and WJ-SX650 MATRIX SWITCHER SETUP
- ® UNIT column
- (D TITLE column
- © SET button
- @ INDEX column
- © USER AUTHORIZATION
- © USER REGISTRATION
- @ DELETE USER
- CD HOST AUTHORIZATION
- (D HOST REGISTRATION
- CD DELETE HOST
- ® DATE
- ® TIME
- (D DAYLIGHT SAVINGS
- © MENU ON/OFF
- © ESC
- © MOVE CURSOR - Left
- © MOVE CURSOR - Up
- ® MOVE CURSOR-Down
- ® MOVE CURSOR-Right
- © SET
- ® ALL RESET
- ® RESET
- ® ZOOM/FOCUS
- ® CAMERA SELECT
- @ Live Image & Camera Setup Menu Display
- © RECEIVING MODE READY STATE
- (D RINGER
- © CALLING IP ADDRESS CHECK
- © REJECT IP/SUBNET MASK REGI.
- © ACCEPT IP/SUBNET MASK REGI.
- ® IP ADDRESS
- ® AUTOMATIC DISCONNECTION TIMER
- (D DAYH'IME
- (D Alarm Call Address, ALARM PORT NO.
- Example of Alarm Table Setting
- Alarm Table Setting
- Ф ONE-TOUCH DIALING REGISTRATION
- ® RE-CONNECTION
- (D HOST PORT
- ® ON SCREEN DISPLAY
- ® LOCK/PASSWORD
- ■ How to Read ADMINISTRATOR SETUP PAGE
- MAINTENANCE
- MAINTENANCE INDEX FILE SELECT
- ® WJ-SX550B CAMERA MENU SETUP PAGE
- CD WJ-FS616 MENU SETUP PAGE
- ® PSD MENU SETUP PAGE
- (D PSD CAMERA MENU SETUP PAGE
- (D WJ-FS616 CAMERA MENU SETUP PAGE
- ® MENU buttons
- © ESC button
- © MOVE CURSOR buttons
- @ SET button
- ® CAMERA SELECT
- ® RESET buttons
- (D MENU buttons
- d) MOVE CURSOR buttons
- (4) SELECT buttons
- (D ESC button
- Q) MOVE CURSOR buttons
- © SET button
- © CAMERA SELECT buttons
- ©RESET buttons
- © UNIT SELECT
- ® INPUT SELECT
- © CAMERA SELECT
- © MENU buttons
- ® ESC button
- ® MOVE CURSOR buttons
- © SELECT
- ® SET button
- 0 MENU buttons
- 0 ESC button
- 0 MOVE CURSOR buttons
- © SET button
- © CAMERA SELECT
- © RESET buttons
- ® UNIT SELECT
- ® INPUT SELECT
- MAINTENANCE INDEX FILE SELECT
- MLITYiSOMARE
- Ä8CESS AUTHORIZATION
- EXTENSION FUNCTIONS
- ■ WJ-MP204 Data Multiplexer Control
- ■ WJ-FS616 Video Multiplexer Control
- • Connection
- • Setup
- ® CAMERA SELECT
- ® PRESET SELECT
- CD WJ-FS616 CONTROL PANEL
- (4) WJ-HD100 CONTROL PANEL
- ® VCR CONTROL PANEL
- (D VCR/CAMERA SELECT
- ® MULTISCREEN SELECT
- ® PRESET SELECT (Bottom window panel)
- ® ALARM ALL RESET
- ® PAN7T1LT
- © ZOOM
- © FOCUS
- © IRIS
- © AUTO PAN
- ® Status Window
- © Image Display
- @ REW
- @ PAUSE
- VARIABLE FAST
- PLAY
- FF
- ® REW
- ® REV-PLAY
- PAUSE
- ® FF
- STOP
- REC
- T/L MODE UP
- T/L MODE DOWN
- • Random Input Selection Mode
- • Setup
- • Control Operation
- (D WJ-SX550 A/B OUTPUT
- © CAMERA SELECT (Left window panel)
- © PRESET SELECT (Left window panel)
- ® CAMERA PRESET REGISTRATION
- (D LOGOUT
- © CAMERA SELECT (Bottom window panel)
- Q) PRESET SELECT (Bottom window panel)
- © ALARM ALL RESET
- © PAN/TILT
- ® ZOOM
- @ FOCUS
- @ IRIS
- ® AUTO PAN
- 0 Status Display
- 0) Image Display
- Random Input Selection Mode
- • Setup
- • Control Operation
- ■ WJ-FS309/FS316/FS409/FS416 Video Multiplexer Control
- • Connections
- • Setup
- • Control Operation
- CD WJ-NT204 CAMERA SELECT
- ® INPUT from FRAME SWITCHER
- ® ALARM LIST (WJ-NT204)
- ® CAMERA CONTROL Buttons
- ® Status Window
- ® ALARM RESET
- ® WJ-NT204 CAMERA PRESET REGISTRATION
- ® FS CAMERA SELECT
- ® MULTISCREEN SELECT
- © SEQ
- ® STILL
- © EL ZOOM
- ® VCR/CAMERA SELECT
- © UP DOWN LEFT RIGHT Buttons
- © EL ZOOM ON
- © EL ZOOM OFF & RETURN TO CAMERA CONTROL
- • Connections
- • Setup
- • Control Operation
- © CAMERA SELECT
- ® AUX
- © ALARM LIST (WJ-NT204)
- ® ALARM RESET
- ® HD100 ALARM LISTON
- ® CAMERA PRESET REGISTRATION
- ® Camera Control Buttons
- ® Status Window
- ® Image Display
- ® REW
- ® REV-PLAY
- © PREV FRAME
- © PAUSE
- ® NEXT FRAME
- © FF
- © VARIABLE PLAY SLOW
- © VARIABLE PLAY FAST
- © PLAY STOP
- © REC
- ® REC STOP
- © TIME & DATE Search
- © MOVE CURSOR
- ® PLAY/SET
- © ALARM LIST OFF
- 1. Address Setup
- 2. Communication Parameter Setup
- 3. Input Assignment
- © WJ-NT204 CAMERA SELECT
- ® INPUT from WJ-HD500
- © WJ-NT204 ALARM LIST
- © ALARM RESET
- © CAMERA PRESET REGISTRATION
- © Camera Control Buttons
- © Status Window
- © Image Display
- ® WJ-NT204 CONTROL PANEL
- ® WJ-HD500 CONTROL PANEL
- (0) CAMERA CONTROL
- ® MULTISCREEN SELECT
- LIST THUMBNAIL
- (Q) ALARM RESET
- @ WJ-HD500 Control Buttons
- • Connections
- • Setup for Peripheral Devices
- • Setup for WJ-NT204 Transmitter
- • Control Operation for WJ-HD500
- © UniVSystem SELECTION
- © WJ-HD500 SELECT
- © CAMERA SELECT
- @ MULTISCREEN SELECT
- ® LIST/THUMBNAIL
- ® ALARM RESET
- (8) REV-PLAY
- CD PREV FRAME
- ® PAUSE
- © NEXT FRAME
- © PLAY
- © FF
- ® PREVRECORD
- © NEXT RECORD
- © PLAY STOP
- © RECSTOP
- © Status Window
- © Image Display
- © UP DOWN LEFT RIGHT Buttons
- © ALARM SEARCH
- © PLAY
- (g) RETURN TO LIVE VIEW
- ■ PS Data System Control (WJ-FS416, WJ-MP204s and WJ-HD100)
- ■ Uploading a File
- Content Storage Memory
- ■ Image Display
- ■ Camera Operation
- ■ Substitute Character Strings in HTTP Server
- ™iIIBLESHOOflNG
- SPEGIFICATIONSj
- APPENDll
- IMPORTANT SAFETY INSTRUCTIONS