Random input selection mode, Setup, Control operation – Panasonic WV-CU20 User Manual
Page 114
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
IWJ-DR200 AV Disc Recorder Control
Connections
Random Input Selection Mode
(1) Connect CAMERA 1 and 2 to the VIDEO IN 1 and 2 connectors on the rear of the WJ-NT204.
(2) Connect the VIDEO OUT 1 and 2 connectors on the rear of the WJ-NT204 to the VIDEO IN A and B connectors of the
WJ-DR200.
(3) Connect the VIDEO OUT connector of the WJ-DR200 to the VIDEO IN 3 connector of the WJ-NT204,
(4) Connect the RS-232C ports (of WJ-DR200 and WJ-NT204) with a RS-232C cable.
• For VIDEO INPUT SELECTION MODE under OPERATION MODE SELECT, mark RANDOM INPUT SELECTION MODE,
• Enables control of cameras connected to the VIDEO IN connector of the WJ-NT204 (requires customizing the WJ-
DR200 OPERATION VIEV\/ window).
• Unless a user changes channels, the last selected channel is used to continue transmission.
• Setup
Files to be used are as follows. Consult your dealer for these files, because the files are not included
For H.323/H261: [drindex.html]
For JPEG: [jdrindex.htm!]
In the SERIAL PORT SETUP window, set TYPE under RS-232C to WJ-DR200. Set the same communication parameters as for
the WJ-DR200 AV Disc Recorder. (For further details refer to the operation manual of the WJ-DR200 AV Disc Recorder.)
• Control Operation
On the Location bar, type the URL access the WJ-DR200 OPERATION VIEVtf window for the
AV Disc Recorder.
OSBEE2EE2B
................................................... .. .
(9) ®
®
114