Panasonic WV-CU20 - Manual (Page 58)

1. Press the DIAL button.
The DIRECT DIAL dialog appears.
4. To terminate the call, hold down the DIAL button for 2
seconds. The dialog changes to "LINE TERMINATED”.
----------------------------------------------
r----------------------------------------------
■DIRECT DIAL ■LINE TERHIHATED
IP ADDRESS:
ENTER IP ADDRESS,THEN PRESS CALL
KEY,DIALING.
<—>:HOVE CALL:CALL DEL:HO.CLEAR ESC:CLEAR
ONE TOUCH DIAL ¡CALL
REDIAL:REDIAL NO. DIAL/ESC:CLEAR
^______________________________________________ / 1 ______________________________________________ J
2. Press the REDIAL button. The dialog screen displays
the IP address that has been the latest dialing.
■DIRECT DIAL
IP ADDRESS:
192.168. 0. 11
ENTER IP ADDRESS,THEN PRESS CALL
KEY,DIALING.
<—^:MOVE CALL:CALL DEL;NO.CLEAR
ONE TOUCH DIAL ¡CALL
REDIAL;REDIAL HO. DIAL/ESC :CLEAR
■ Sequential Dialing (Receiver)
The sequential dialing can be operated only at the Control
site to call the Remote sites one after another. The dialing
sequence traces the sites that are designated to SEQ. ON
in the 320 QCK# LIST. The sequence also follows the
assignments specified in the 330 SEQ.DIAL setup. It starts
with the start site, retains communication for the duration,
advances to the next site, and repeats the round if applied.
3. Press the CALL button. The dialog screen changes to
"CONNECTING" and the unit starts dialing.
2-3
2-1
2-2
1. Press the QUICK button.
The QUICK dialog appears accompanied with the
directory.
During communication, the CONNECT indicator will illu­
minate.
UNK 10D RWQ.VOt 1
(Si<£E
1
tJkSiJX COtMCT ACT
□ a □ o
ixm" ÌKH
■QUICK DIAL
QUICK#:
N0.
IP ADDRESS:
DIRECTORY:
001 Trans.01
002 Trans.02
003 Trans.03
004 Trans.04
005 Trans.05
Tli-^:MOVE CALL ¡CALL DEL:BS
ENT¡SELECT DIAL/ESC:CLEAR
58