Panasonic WV-CU20 - Manual (Page 50)

1. open the 642 CALUNG LOG menu.
r \
642 CALLIHO LOG 1/16
78 JAM.03 16:00 L DISC
192.168. 0. 14
77 JAN.02 21:00 CALLING
192.168. 0. 14
76 JAN.02 18:00 R DISC
Recelver04
75 JAN.01 06:00 CALLED
Receiver04
74 JAN.01 00:00 L DISC
192.168. 0. 11
TiNEXT COM J-iPRV COM ESC:PRV
You can check every 5 events in chronological order
on the monitor at a time. The event type is denoted as
follows.
CALUNG: Calling made in the site
CALLED: Reception made in the site
L*DISC: Disconnection took place in the site
R-DISC: Disconnection took place in the other site
CLD: Calling site received during communication
2. Press the A or T button to scroll up or down the page.
3. Press the ESC button to return the menu to the previ­
ous.
650 SERIAL DATA PORT
This menu lets you check the serial port setup whether to
be the same as that of the other site concerned.
1. Open the 650 SERIAL DATA PORT menu.
660 LOCAL LOOPBACK (In Standby Only)
This test simulates how much quality of the video and audio
are received without routing signals to the other site.
Thanks to the built-in circuit to the unit, the simulated video
appears on the monitor, and the audio comes out via the
speaker in its-own site.
1. Open the 660 LOCAL LOOPBACK menu.
660 LOCAL LOOPBACK
MODE : VIDEO AUDIO
>:HOVE EHTiEXEC ESC;PRV
2. Move the cursor to VIDEO or AUDIO, then press the
ENTER.
VIDEO: Simulated video appears on the monitor.
AUDIO: Simulated audio is supplied through the
speaker.
Observe the simulated video or audio carefully. The
monitor screen changes blue when no video is sup­
plied to the unit.
3. Press the ESC button to return the window to the previ­
ous one.
Note: Video switch changing can not be implemented
during the local loopback test.
650 SERIAL DATA PORT
RATE
DATA
BITS
STOP BITS
PARITY
LOCAL
9600
8
1
НОЫЕ
REMOTE
9600
8
1
NOME
ESCIPRV
2. Observe each parameter comparing with that of the
other site. If you find any difference, remedy to match
both settings as the same.
3. Press the ESC button to return the menu back to the
previous.
670 VERSION
Software versions are displayed on the monitor.
1. Open the 670 VERSION menu.
All versions for the REMOTE site are displayed as
000000-00 in the standby status, but in communication
they will be displayed.
2. Press the ESC button to return the window to the previ­
ous one,
50