Panasonic WV-CU20 - Manual (Page 38)

300 DIRECTORY DIALING REGI. 3. Enter the IP address with the numeric buttons.
IP addresses and titles are registered in the directory for
Quick, One-touch and Sequence dialing.
The 330 SEQ DIALING REGI. appears only when the unit is
set to a receiver.
300 DIRECTORY/DIALING REGI.
310 DIRECTORY REGI.X
320 ONE TOUCH DIALING REGI. 4.
330 SEQ, DIALING REGI. 4L
TJ.:MOVE ENT:SELECT ESC:PRV
1. The 300 DIRECTORY DIALING REGI. menu appears
when you press the ENTER button after selecting it in
the 000 TOP menu.
2. Select a menu you wish to set up from the 310 or 320
and 330, then press the ENTER. The selected menu
appears.
310 DIRECTORY REGI.
Up to 200 Quick dialing addresses are registered in the
directory.
N0.002
IP ADDRESS
192.168. 0. 12
(TITLED)
SEQ.DIAL: ON OEP
tI^->;H0VE DEL:CLEAR BSC:PRV
4. Move the cursor to (TITLE-l) and press the ENTER. The
TITLE submenu appears.
TITLE: Trane.02
ABCDEEGHIJ
KLKNOPQRST
UVWXYZ
abcdefgblj
klmnoparst
uvwxyz
0123456789
■ "#&<)
*+,
(TITLE COPY4)
ENT;SELECT ESC:PRV DEL:BS
310 DIRECTORY REGI.
QCK# TITLE
001 Trans.01
002
003
004
005
006
007
008
009
010
SEQ.DIAL
OFF
HO. t4-:MOVE ENTiSELECT ESCiPRV
1. Open the 310 DIRECTORY REGI. menu. On the left end
column, the quick numbers (QCK#) from 001 to 010 are
displayed.
2. Enter a number from 001 to 200 with the numeric but­
tons, or select a QCK# with the A or T button, then
press the ENTER. The submenu for individual number
appears.
Note: The A and ▼ buttons may not move when the
cursor is placed in the No. field on the bottom line,
and the selected QCK# has not registered con­
tents yet or only "0“ is registered for it. When this
happens, enter a number 001 through 200, then
use the A or T button
5. Select a character with the direction button, then press
the ENTER. The selected character appears on the top
line. A maximum of 10 characters can be selected.
6. Repeat step 5 above until all characters are entered,
then press the ESC button. The window returns to the
submenu for individual number displaying the entered
title.
7. You can copy a pre-existing title to a new one for con­
venience as follows.
7-1 In the step 5, move the cursor to (TITLE COPYT),
then press the ENTER. The QUICK # TITLE list
appears.
7-2 Move the cursor to the title in the list you wish to
copy, then press the ENTER. The individual sub­
menu (similar to step 3) appears with the copied
title.
7-3 Go back to step 4 when you edit the copied title.
8. Move the cursor to SEQ.DIAL for the RECEIVER and
select either ON or OFF with the ^ or ► button. The
default setting is OFF.
ON: The terminal is included in as one step of the
sequential dialing.
OFF: The sequential dialing excludes the terminal.
9. Repeat step 2 through step 8 above to enter for other
quick numbers (QCK#).
38