Dynojet WinPEP 7 - Manual (Page 92)

WinPEP 7 User Guide
C H A P T E R 6
Load Control
6-22
7 Click the Load Control button to turn on Load Control. You can also use
the letter L on your keyboard.
The yellow indicator light will be on when Load Control is on.
As you approach the Load Control set point, the brake will begin to apply. If you
wish to collect data while in Load Control, you may start sampling.
Note: Load Control will automatically turn off when the run starts if the “Turn Off
Load Control When Run Starts” option is selected. When this feature is off, Load
Control will remain on during the run and the Status Bar on the MakeRun screen
will flash “Sampling. . .” and “Load Control On” alternately. Refer to page 6-5 for
more information.
8 Turn off Load Control by clicking the Load Control button .
Note: When ending a run with Load Control on, Dynojet recommends using the
brake (red button on your pendant).
Figure 6-20: Load Control
load control button
load control set
point marker
yellow load control
indicator light
selection ring
load control
value edit