Dynojet WinPEP 7 - Manual (Page 46)

WinPEP 7 User Guide
C H A P T E R 3
MakeRun and Your Dyno Electronics
3-12
Use the following steps to verify the dyno electronics is properly connected to your
computer and communicating with WinPEP 7.
1 Verify the dyno electronics is on and connected to your computer.
2 Make sure you are in the MakeRun screen.
3 Select Search ! Find Dyno Electronics.
WinPEP 7 automatically searches for the dyno electronics.
If WinPEP 7 is unable to find the dyno electronics, a message telling you the dyno
electronics was not found will appear. Verify the dyno electronics is on and
connected to your computer. Have WinPEP 7 search for the dyno electronics
again.
4 In our example, the dyno electronics was found. Click OK.
The message, “Clear Area Behind Dyno!” in the Status Bar indicates WinPEP 7 is
connected and ready to proceed.
Figure 3-6: Dyno Electronics—Connected