Dynojet WinPEP 7 User Manual
Page 59

M A K I N G A R U N
Making a Run
Version 2
WinPEP 7 User Guide
4-5
6
Begin acceleration.
• Standard Transmission—Place the vehicle in first gear and engage the clutch
to start the drum rolling. Shift through gears to fourth and hold the RPM at the
desired point. A good starting RPM is at the lowest RPM where there is little
hesitation when you snap the throttle all the way open or floor the accelerator
(usually around 2000 to 3000 RPM).
• Automatic Transmission—Start the drum(s) rolling and accelerate to ten
m.p.h.
7
Push the green sampling button on your pendant to begin sampling.
8
Snap the throttle all the way open (or floor the accelerator) and accelerate to
redline.
Note: If you are making a
Negative Horsepower” on page 4-7.
The status bar will show the message, " Sampling...", the run timer will start, and
the green indicator light will be on.
Figure 4-3: Making a Run—Sampling
9
Let off the throttle and press the green sample button to end sampling.
10 Press the red brake button to apply 100% braking and slow down the vehicle.
You can also press the red brake button to automatically end the run and apply
100% braking.
Note: When using
, Dynojet recommends using the brake button to
end the run.
status bar
indicator light
run timer