Dynojet WinPEP 7 - Manual (Page 85)

A D V A N C E D M A K E R U N F E A T U R E S
Creating and Editing Gauges (Templates)
Version 2 WinPEP 7 User Guide
6-15
4 Edit the gauge properties.
Each type of gauge has a slightly different dialog box, but most share the same
properties.
4a
Right click on the gauge and choose Gauge Properties.
The Gauge Property Editor dialog box will appear.
4b Select a Data Channel from the drop down list.
Data Channel is probably the most important property. Data Channel
determines which channel the gauge is linked to (such as speed and RPM).
The Data Channel selected automatically appears in the Upper Title and on
the gauge.
Note: You must be connected to the dyno electronics for the list of channels
to be available.
Note: The channels in the list will differ depending on the modules in the
dyno electronics. For example, Air/Fuel will not appear in the list if you do
not have an Air Fuel Module.
4c The upper title is set automatically when Use Default Titles on Gauges is
selected. Refer to page 6-19 for more information.
The lower title is set automatically when Display Units on Gauges is
selected. Refer to page 6-19 for more information.
Do not change these titles if you want them to change automatically when
language and units are changed.
4d Move the Digital Display slide bar to change the digital display size on the
gauge.
Notice how the display changed on the gauge.
4e Click OK to enter these changes or click Cancel to abort the changes and
return to the MakeRun screen.
Figure 6-15: Edit Gauges—Gauge Property Editor
lower title
digital display
upper title
data channel
drop down list
digital display
slide bar