Dynojet WinPEP 7 - Manual (Page 154)

WinPEP 7 User Guide
A P P E N D I X G
G-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DIABLOSPORT PREDATOR SET UP
DiabloSport Predator is a high performance tuning flash programmer and datalogger.
The Predator connects to a vehicle’s OBDII data port and enhances the performance
of the vehicle. The Predator can also act as a high speed datalogger allowing data to be
transmitted and stored during a dyno run. This data can then be analyzed and
reviewed in the WinPEP 7 software. This industry first and industry exclusive feature is
great for PCM tuning and maintaining consistency while dyno testing. Visit
www.diablosport.com for more details.
C ONFIGURING D IABLO S PORT P REDATOR
1 Plug the DiabloSport Predator into the vehicle’s OBDII port.
2 Turn the vehicle’s key to the on position or start the vehicle.
3 Verify you are in the MakeRun screen.
4 Verify you are connected to the dyno electronics. Refer to “Dyno Electronics” on
page 2-4 for more information.
5 Click the MakeRun Configuration button .
6 Click the Expansion Systems tab.
7 Select DiabloSport Predator.
8 Click the Configure button.
Figure G-1: MakeRun Configuration—Expansion Systems
configure button
expansion
systems tab