Dynojet WinPEP 7 - Manual (Page 124)

WinPEP 7 User Guide
A P P E N D I X D
Analog Channel Configuration
D-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ANALOG CHANNEL CONFIGURATION
You can configure up to four different analog channels. Use the following instructions
to configure the analog channel(s).
C ONFIGURING THE A NALOG C HANNEL ( S )
1 Verify you are in the MakeRun screen.
2 Verify you are connected to the dyno electronics.
Note: You must be connected to the dyno electronics and the Analog Module
must be installed for the analog channels to be available.
For more information on connecting to the dyno electronics refer to “Connecting
the Dyno Electronics” on page 3-11. For more information on installing the
Analog Module refer to the Analog Module Installation and User Guide.
3 Select Tools ! MakeRun Options ! Analog Configuration.
4 Select the desired analog channel tab.
5 Click the Enable logging on this channel check box.
6 Click Sensor Helper.
Figure D-1: Analog Configuration Window—Select Desired Channel
analog channel tabs
sensor helper
check box