Dynojet WinPEP 7 - Manual (Page 9)

S P E C I F I C A T I O N S A N D I N S T A L L A T I O N
WinPEP 7 Specifications
Version 2 WinPEP 7 User Guide
1-3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
WINPEP 7 SPECIFICATIONS
Your WinPEP 7 software is dynamometer/ drum specific. That means that the precise
drum mass for your individual dynamometer has been calibrated and tied directly to
the WinPEP 7 software that came with your dynamometer. The software will not
record accurate results if it is used with any other dynamometer.
C OMPUTER S PECIFICATIONS
You will need to provide a computer system to run the WinPEP software.
L ICENSE A GREEMENT
The user license agreement for WinPEP 7 can be found in Appendix C of this manual.
Please read the User License Agreement carefully and be sure you understand and
accept the terms of the agreement.
R EGISTRATION
Registering your software helps Dynojet provide technical support and inform you
about new software developments. To register, go to www.winpep.com .
Figure 1-1: Registering Your Software
minimum system requirements recommended systems requirements
• Microsoft® Windows 2000/XP • Microsoft® Windows 2000/XP
• Pentium 800 MHz Processor • 2.4 GHz Processor or greater
• 256 MB of available RAM • 256 MB of available RAM or greater
• one COM port , two COM ports for Tuning
Link
• one COM port, two COM ports for Tuning Link
• 800 x 600, 256 color monitor (SVGA) • 1280 x 1024 256 color monitor (SVGA) or better
• 1.2 gigabyte hard drive • 1.2 gigabyte hard drive
• 30 MB of available hard-disk space • 100 MB of available hard-disk space
• CD ROM and floppy disk drive • CD ROM and floppy disk drive
• printer, if hard copies are needed • printer (preferably HP DeskJet®)
click here to
register