Dynojet WinPEP 7 - Manual (Page 79)

A D V A N C E D M A K E R U N F E A T U R E S
Run Options
Version 2 WinPEP 7 User Guide
6-9
U SING A UTO S TART /S TOP
1 Make sure you are in the MakeRun screen.
2 Verify you are connected to the dyno electronics. Refer to “Connecting the Dyno
Electronics” on page 3-11 for more information.
3 Click the MakeRun Configuration button .
4 Click the Run Options tab.
5 Select Automatically Start/Stop Run.
6 Choose one of the available channels, Engine Speed or Speed.
7 Enter the Start and Stop values.
8 Click OK.
9 Get your vehicle running and up to speed.
10 If you did not turn Auto Start/Stop on in step 5, you will need to do one of the
following:
• click the Stoplight button
• start and stop your run by pressing the green button on your pendant instead
of using Auto Start/Stop.
11 Accelerate to the start value and sampling will begin.
12 Continue to accelerate to the stop value to end sampling.
13 Slow down or use the emergency brake to drop below the start value to begin the
next run.